Bandwidth

DC ~ 350MHz (–3dB) @50Ω/1MΩ input impedance

Rise time

1ns (calculated)

Bandwidth限制

20MHz/100MHz/200MHz*

GDS-3652A

Channel

2 + Ext

Bandwidth

DC ~ 650MHz (–3dB) @ 50Ω input impedance

DC ~ 500MHz (–3dB) @1MΩ input impedance

Rise time

535ps (calculated)

Bandwidth限制

20MHz/100MHz/200MHz/300MHz*

*Bandwidth限制公差为±10%.

Vertical sensitivity

Resolution

8 bits (Max.12 bits with Hi Res)

For 1MΩ input impedance: 1mV*~10V/div

For 50Ω input impedance: 1mV*~1V/div

Input coupling

AC, DC, GND

Input impedance

1MΩ// 22pF approx.

DC gain accuracy

1mV: ±5% full scale
≥2mV: ±3% full scale

Polarity

Normal & Invert

Maximum input voltage

For 1MΩ input impedance: 300Vrms, CAT II

For 50Ω input impedance: 5Vrms max.

Offset position range

For 1MΩ input impedance:

1mV/div ~ 20mV/div :±1V; 50mV/div ~ 500mV/div: ±10V

1V/div ~ 5V/div : ±100V; 10V/div : ±1000V

For 50Ω input impedance:

1mV/div ~ 50mV/div:±1V; 100mV/div ~ 1V/div : ±10V

Waveform signal processing

+, -, ×, ÷, FFT, User Defined Expression

FFT: Spectral magnitude. Set FFT Vertical Scale to Linear RMS or dBV RMS, and FFT Window to Rectangular, Hamming, Hanning or Blackman.

Trigger

Source

CH1, CH2, Line, EXT

Trigger模式

Auto (supports Roll Mode for 100ms/div and slower), Normal, Single

Trigger类型

Edge, Pulse Width(Glitch), Video, Pulse Runt, Rise & Fall(Slope), Timeout, Alternate, Event-Delay(1~65535 events), Time-Delay(Duration, 4ns~10s), Bus (UART, I2C, SPI, CAN, LIN)

Holdoff 范围

4ns to 10s

Coupling

AC, DC, LF rej., HF rej., Noise rej.

Sensitivity

1div

外部Trigger

Range

±20V

Sensitivity

DC ~ 100MHz Approx. 100mV
100MHz ~ 350MHz Approx. 150mV

Input impedance

1MΩ±3%~22pF

*:在1mV/div和2mV/div下,Bandwidth限制为20MHz.

Horizontal

Time base range

1ns/div ~ 1000s/div (1-2-5 increments)
ROLL: 100ms/div ~ 1000s/div

预Trigger

10 div maximum

后Trigger

10,000,000 div maximum.

Time base accuracy

±5 ppm, about ±2ppm increase in error per year

Signal acquisition

Real-time sampling rate

5GSa/s one channel;

2.5GSa/s dual channels

Record length

Max. 200Mpts /CH

Collection mode

Normal, Average, High Resolution, Peak Detect, Single

Peak detection

400ps (typical)

On average

Selectable from 2 to 256

The number of segments

1 to 490,000 maximum

The X-Y pattern

X-Axis input

Channel 1

Y-Axis input

Channel 2

Phase shift

±3° at 100kHz

Cursor and measurement

Cursor

Amplitude, Time, Gating available;

Unit: Seconds(s), Hz (1/s), Phase (degree), Ratio (%).

Automatic measurement

38 sets with indicator: Pk-Pk, Max, Min, Amplitude, High, Low, Mean, Cycle Mean, RMS, Cycle RMS, Area, Cycle Area, ROVShoot, FOVShoot, RPREShoot, FPREShoot, Frequency, Period, RiseTime, FallTime, +Width, -Width, Duty Cycle, +Pulses, -Pulses, +Edges, -Edges, %Flicker, Flicker Idx ,FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF, Phase.

Cursor测量

Voltage difference between cursors(∆V)

Time difference between cursors(∆T)

Automatic counter

6 digits, range from 2Hz minimum to the rated bandwidth

Control panel function

Autoset

Single-button, automatic setup of all channels for vertical, horizontal and trigger systems, with “Undo Autoset”, “Fit Screen”/ “AC Priority” mode, and “Fine Scale” functions.

Save the Settings

20 sets

Save the waveform

20 sets

Save the reference waveform

4 sets

Power supply measurement

(Optional)

Power Quality, Harmonics, Ripple, In-rush current, Switching Loss, Modulation, SOA, Transient, Efficiency, B-H curve, Control Loop Response, PSRR, Turn On/Off

AWG

In general

Channel

2

Sample rate

200MSa/s

垂直Resolution

14 bits

频率

25 MHz

Waveform

Sine, Square, Pulse, Ramp, DC, Noise

Sinc, Gaussian, Lorentz, Exponential Rise, Exponential Fall, Haversine, Cardiac

Output range

20 mVpp to 5 Vpp, HighZ;

10 mVpp to 2.5 Vpp, 50Ω

输出Resolution

1mV

Output accuracy

2% (1 kHz)

Offset range

±2.5 V, HighZ; ±1.25 V, 50 Ω

偏移Resolution

1mV

Sine

Frequency range

100 mHz to 25 MHz

平坦度
(relative to 1 kHz)

±0.5 dB <15MHz;

±1dB 15MHz~25MHz

Harmonic distortion

-40 dBc

Stray (non - harmonic)

-40 dBc

Harmonic distortion

1%

S/N Ratio

40 dB

Square wave/pulse wave

Frequency range

Square: 100 mHz to 15 MHz

Rise/fall time

<15ns

Overshoot

<3 %

Duty cycle

Square: 50%

Pulse: 0.4% to 99.6%

Minimum pulse width

30ns

Jitter

500 ps

The slope

Frequency range

100 mHz to 1MHz

Linearity

1%

Symmetry

0 to

Spectrum analyzer

Frequency range

DC~2.5GHz Max, dual channel with spectrogram (based on Advanced FFT).

Notice: Frequency which exceeds analog front end bandwidth is uncalibrated

Span

1kHz~2.5GHz (Max.)

ResolutionBandwidth

1Hz~2.5MHz (Max.)

Reference level

-80dBm to +40dBm in steps of 5dBm

Vertical unit

dBV RMS; Linear RMS; dBm

Vertical position

-12divs to +12divs

Vertical scale

1dB/div to 20dB/div in a 1-2-5 Sequence

Show的On average噪声级

1V/div ß -40dBm, Avg :16

100mV/div ß -60dBm, Avg :16

10mV/div ß -80dBm, Avg :16

Stray response

2nd harmonic distortion <35dBc

3rd harmonic distortion <40dBc

Frequency domain tracking type

Normal; Max Hold; Min Hold; Average (2 ~ 256)

Detection method

Sample; +Peak; -Peak; Average

FFT window

FFT Factor:
Hanning 1.44
Rectangular 0.89
Hamming 1.30
Blackman 1.68

逻辑分析仪(Optional)

Sample rate

1GSa/s

Bandwidth

200MHz

Record length

Per Channel 10M points (max)

输入Channel

16 Digital (D15 - D0)

Trigger类型

Edge, Pattern, Pulse Width, Serial bus (I2C, SPI, UART, CAN, LIN), Parallel Bus

Critical value grouping

Settable thresholds for:

D0-D3, D4-D7, D8-11, D12-15

Critical value selection

TTL, CMOS(5V,3.3V,2.5V), ECL, PECL,0V ,User Defined

用户定义的临界值范围

±5V

Maximum input voltage

±40 V

Minimum driving voltage

±250 mV

垂直Resolution

1 bit

Frequency Response Analyzer

Frequency range

20Hz to 25MHz

Input and output sources

Channel 1 ~ 2

Number of test points

10, 15, 30, 45, 90 points per decade selectable for logarithm scale;

2 ~ 1000 points selectable for linear scale

Dynamic range

> 80dB (typical)

Test amplitude

10mVpp to 2.5Vpp into 50Ω, 20mVpp to 5Vpp into High-Z, Fixed test amplitude or custom amplitude for each decade.

The test results

Logarithmic or linear overlaid gain and phase plot, may also overlay with reference plots for cross comparison. Test results saved in csv format for offline analysis.

Manual measurement

Tracking gain and phase markers

Drawing scale

Auto-scaled during test

Show

TFT LCD Type

10.2" TFT LCD WVGA color disy

ShowResolution

800 horizontal × 480 vertical pixels (WVGA)

内插方式

Sin(x)/x

WaveformShow

Dots, vectors, variable persistence (16ms~4s), infinite persistence, gray or color waveforms.

Waveform更新率

200,000 waveforms per second, maximum

Show格线

8 x 10 divisions

Show模式

YT, XY

Interface

USB Port

USB 2.0 High-speed host port X1, USB High-speed 2.0 device port X1

Ethernet (LAN)

RJ-45 connector X1, 10/100Mbps with HP Auto-MDIX

Go-NoGo BNC

5V Max/10mA open collector output X1

Power Supply Receptacles

±12V / 600mA for current probe use.

Two sets of power supply receptacles for 2CH models;

RS232C

DB-9 male connector X1

VGA image output

DB-15 female connector X1, monitor output for disy on VGA monitor

The optional GPIB module

Fully programmable with IEEE488-2 compliance

Kensington security lock slot

Rear-panel security slot connects to standard Kensington-style lock.

Other

Multilingual menu

Available

Operating environment

Temperature: 0°C to 50°C. Relative Humidity ≤ 80% at 40°C or below;
≤ 45% at 41°C ~ 50°C.

Screen help

Available

Time function

Time and Date, Provide the Date/Time for saved data

Built-in Flash storage space

800M bytes Single-Level Cell flash memory

Built-in APP

Go/NoGo, DVM, DataLog, Digital Filter, Frequency Response Analyzer, Mask, Mount Remote Disk, Demo

User - defined keys

User can select one of the several different preset functions as shortcut key.

Rated voltage range and power consumption

AC 100V ~ 240V, 50Hz ~ 60Hz, auto selection. power consumption:100W

The weight of

Approx. 4.6kg

Size

420mm(W)X 253mm(H)X 113.8mm(D)