| Model number | UT262D |
| Work energy | Phase detection (positive phase, reverse phase), wire inspection, simple electricity detection, lack of phase judgment, break search, breakpoint location, line maintenance |
| Electricity source | 9V battery, continuous use time about 70 hours. |
| Measurement mode | Non - contact clamping mode |
| Conductor position | The measured wire is in the center of the pliers |
| Frequency rate | 50Hz/60Hz Automatic identification |
| Active current range | AC70 ~ 1000V,45/65Hz (sine wave continuous input), electrostatic detection. |
| Measure the highest voltage | AC1000V |
| Clamp wire size | Outer diameter ø1.5mm ~ ø48mm |
| Show | 【 positive phase 】R lights up; |
| [reverse phase] L light on; | |
| [Live] Light L1,L2,L3 lamps within the voltage setting range; | |
| [Lack of phase] L1 or L2 or L3 light is not on; | |
| 【 Circuit breaker 】 The L1, L2, or L3 lights are off. | |
| The buzzer | [positive phase] the instrument emits intermittent short sound; |
| The instrument emits a continuous chirp | |
| Battery check | After startup, the indicator light above the button is green; When it turns red, the battery is low |
| Clamp lead length | 0.6m |
| Automatic shutdown | 开机约6分钟后,仪表Automatic shutdown,以降低电池消耗 |
| 电池电压 | When the battery voltage drops to about 5.2V, the power indicator lights up red to remind you to rece the battery |
| Maximum rated power | 300mVA |
| Working temperature and humidity | -10℃ ~ 55℃; 80percentrh below |
| Storage temperature and humidity | -20℃ ~ 60℃; 90percentrh below |
| Insulation strength | 3.7kVrms |
| Suitable for safety rules | EN61010-1:2001,EN61010-031:2002, pollution level 2,CAT Ⅲ(600V), instantaneous overvoltage 6000V. |
